After purchasing two sheets of 16mm MDF (medium density fibre) particle board and 1x 3mm sheet, i set about finding information from the web. there's a yahoo group dedicated to this subject, so i got their official blueprints as my primary guide.
1. Legs - these are two sheets thick with some extra detailing parts. the feet were a nightmare to shape, and are held on with a single bolt.
the head is the hardest part to make. i started with a heap of circles cut from the mdf into a rough dome shape. i then covered it with clay, to shape it and then covered with wall plaster and lots of sanding. i then covered it in fibreglass and resin.
here's where i'm at with it. dunno if i'll ever finish it, but it's starting to look like something
